Hp laserjet p3015 toner replacement4/6/2024 The issue is due to the fuser not heating up properly. Power cycling the printer will usually allow it to print again for a little while until it does it again. “Processing job…” message appears on display panel and printer hangs.Īnother symptom that may result from a bad fuser on an HP P3015 Laserjet printer is if the printer hangs while printing and the message “Processing job…” can be seen on the display panel. It is for a different model printer but the process is almost the same. The following video explains how to replace a bad fuser sleeve step by step. If you want to save some money it is possible to replace just the fuser sleeve rather than the whole fuser but this will require more work on your part. The black ink marks are due to a bad fuser sleeve that has been worn or is damaged. These black ink marks get worse over time and don’t go away. There are no visible signs of residual ink or it has been cleaned. The paper prints out with black ink marks.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |